Owner’s manual – Tanaka TBC-340/D User Manual

Page 12

Advertising
background image


www.tanaka-usa.com 11 [email protected]

Owner’s Manual

TBC-250/250PF/PFD,TBC-2501,TBC-2510,TBC-270PF/PFD

TBC-270PN/PND,TBC-300/SDH/3010,TBC-340/D,TBC-340PF/D

Cutting (Fig. 2-4, 4B, 4C, 4D)

• When cutting, operate engine at over 6500 rpm. Extended use at a low rpm will wear the clutch prematurely.
• Cut grass from right to left.
• Blade thrust may occur when the spinning blade contacts a solid object in the critical area. A dangerous reaction may

occur causing the entire unit and operator to be thrust violently. This reaction is called BLADE THRUST. As a result, the

operator may lose control of the unit which may cause serious or fatal injury. Blade thrust is more likely to occur in areas

where it is difficult to see the material to be cut.

• Wear the harness as shown in the figure (if so equipped). The blade turns counterclockwise, therefore, be advised to

operate the unit from right to left for efficient cutting. Keep onlookers out of working area at least 15 m (50 ft.).

NOTE!
Press the quick release button or pull emergency release flap (if so equipped) in the event of emergency. (Fig. 2-4C)

WARNING!

If your cutting attachment should strike against stones or other debris, stop the engine and make sure

the attachment and related parts are undamaged. When grass or vines wrap around attachment, stop the
engine and remove them.

WARNING!

A cutting attachment can injure while it continues to spin after the engine is stopped or power control is

released. When the unit is turned off, make sure the cutting attachment has stopped before the unit is set

down.

Stopping (Fig. 2-5)

Decrease engine speed and run at an idle for a few minutes, then turn off ignition switch.

Advertising
This manual is related to the following products: