Toshiba CARRIER RAV-SP420UT-UL - Manual (Page 19)

Toshiba XXXXXXX(X/X)
– 18 –
4-way Air Discharge Cassette Type
Owner’s Manual
EN
„ Louver lock (No swing)
1
Push (right side of the button) for at
least four seconds when the air conditioner
is not working.
• and numbers flash.
2
Push (left side of the buttom) to
select an indoor unit to be set.
• Each time you push the button, unit numbers
change as follows:
The fan of the selected unit runs and the louvers
start swinging.
3
Push TEMP. buttons to display the
number of a louver you want to lock on the
temperature display.
• The selected louver starts swinging.
4
Push TIME buttons to select the
louver direction of the louver you do not
want to swing.
CAUTION
• If (4) or (5) is selected, condensation may drop from
the unit during operation in cooling mode.
5
Push button to lock the louver.
• When the setting has been determined,
lights up.
(To continue louver lock settings for other indoor
units, repeat from step 2. To continue louver
lock settings for other louvers on the same
indoor unit, repeat from step 3.)
6
Push button to complete the setting.
• A louver number is displayed as F1, F2 on the
remote control (SET DATA), showing that louver
01, 02 shown in the figure on the previous page
is selected.
NOTE
Even when louvers are locked, they move temporarily
in the following cases:
• When the air conditioner is stopped
• At the beginning of heating operation
• During defrosting operation
• When the room temperature has reached the set
temperature
2 1
4
3
UNIT No.
1-1
UNIT No.
1-2
UNIT No.
1-3
UNIT No.
1-4
(1)
0001
(2)
0002
(3)
0003
(5)
0005
(4)
0004
SET DATA
0001-0005
(Louver lock position code)
18-EN
+00EH99933501_00Ta.book Page 18 Tuesday, November 24, 2009 2:25 PM