TRENDnet TEW-430APB - Manual (Page 8)

6
Troubleshooting
Q1: How do I configure TCP/IP settings on my computer?
1. Go into the Control Panel and double-
click the
Network Connections icon,
right-click the
Local Area Connection
icon and then click
Properties.
2. Click Internet Protocol (TCP/IP) and
then click
Properties. Then click on
Use the following IP address, and
make sure you assign your network
adapter an IP address in the subnet of
192.168.1.x.
Q2:
A2:
Q3:
A3:
If my network's IP is different than the Access Point's range, what should I
do?
You should still configure the Access Point first. After all the settings are
applied, go to the Access Point's configuration page, click on TCP/IP settings and
change the IP address of the Access Point to match your network's IP.
I typed http://192.168.1.100 in my Internet Browser's Address Bar, but an
error message says “The page cannot be displayed.” How can I get into the
TEW-430APB's web configuration page?
First, check your hardware settings again by following the instructions in
section 2. Second, make sure the LAN and WLAN lights are lit. Third, make sure
the TCP/IP settings are configured properly (see Q1). Fourth, since the Access
Point's default IP address is 192.168.1.100, make sure that no other network
devices are assigned an IP address of 192.168.1.100.