Toshiba PWU001Z-1 - Manual (Page 4)

E6580724
Caution on operation
Danger
Prohibited
Do not operate keys with a wet hand or wipe with a wet duster.
Not following this instruction could cause electrocution.
Do not shock the Parameter Writer (do not fall down).
Not following this instruction could cause malfunction or breakdown.
Do not pull the transmission cable.
Not following this instruction could cause malfunction or breakdown.
Caution on disposing of Parameter Writer
Warning
Mandatory
Dispose of the Parameter Writer as industrial waste.
Not following this instruction could cause injury.
Notes on operation
NOTES
Install the unit avoiding a place where ambient temperature or/and
humidity change sharply.
Arrange the transmission cable apart from the power cable of the
inverter to prevent the inverter from malfunctioning to be caused by
electromagnetic noise.
Install the unit on the panel of a cabinet if it is used as a remote keypad.
The unit not installed on the panel of a cabinet could cause the unit
falling, resulting in damage and malfunction of the unit.
Install a magnetic contactor etc. to the power supply of the inverter, so
that an emergency stop can be executed securely from outside.
The integrity of data storage is guaranteed for up to 10 years.
The operating life of EEPROM (data storage device) is 10000
operations.
Do not execute writing operations more than 10000 times.
Do not turn off power or remove the connection cable between the
inverter and the parameter writer while a copying operation of parameter
writer is executed. If the inverter power is turned off or the connection
cable is removed while parameters are being copied, data cannot be
written correctly.
Do not copy data from the parameter writer to inverter while the inverter
is running. Some of the parameters cannot be written when the inverter
is in operation.
Make sure to execute “comp” (compare) function to check copied data
when “copy” (copy) function is executed. Depending on
circumstances, data writing of copying operation may not have been
successful.
When a copying operation is executed between two inverters with
different capacities, some of the parameters that vary with the capacity
of inverters will also be copied. Therefore, when you have executed a
copying operation between the inverters with different capacities, we
suggest you initialize the copied parameters of the inverter in
accordance with the level of inverter’s capacity. See the inverter
instruction manual on how to initialize parameters.