Transition Networks TN-GLC-xx-xx - Manual (Page 3)

TN-GLC-xx-xx SFPs
4 Tech Support: 1-800-260-1312 -- International: 00-1-952-941-7600 -- (24 hours)
Connect fiber cable
to media converter
as shown. Connect fiber cable
to other device
(media converter,
hub, etc.) as shown
RX
TX
RX
TX
Installing the fiber cables
1. Locate or build 1000Base-SX-compliant or 1000Base-LX-compliant fiber
cable with male TX to RX connectors installed at both ends.
2. Install the fiber cable as shown below.
[email protected] -- Click the “Transition Now” link for a live Web chat. 5
Cable Specification
Copper cable (Category 5 -- minimum requirement)
• Gauge = 24 to 22 AWG; Attenuation = 22.0 dB /100m @ 100 MHz
• Straight-through OR crossover cable may be used.
• Shielded twisted-pair (STP) OR unshielded twisted-pair (UTP) may be used
• All pin pairs (1&2, 3&6, 4&5, 7&8) are active in a gigabit network.
• Use only dedicated wire pairs for the active pins; e.g., blue/white &
white/blue,
orange/white & white/orange, etc.
• Do not use flat or silver satin wire.
Crossover Cable
1
2
3
6
Straight-Through Cable
Twisted Pair #1 Twisted Pair #1
Twisted Pair #2 Twisted Pair #2
1
2
3
6
1
2
3
6
1
2
3
6