Thermador WDC30 User Manual
Page 8
8
You can attach your own front panel for this warming drawer.
This front panel must:
have a handle
have the dimensions shown on the included template
have a thickness of 3/4" (19 mm) at least
have all edges finished
stand a temperature of 158 ºF (70 ºC).
1.
Built custom drawer according to the dimensions shown on template.
2.
Put template on the back side of the panel, not on the front side!
3.
Mark pilot holes and hole for light wave guide.
4.
Drill pilot holes. Be careful not to drill all the way through the panel!
Pilot holes should only be 7/16" (11 mm) deep.
5.
Drill hole for the light wave guide through the panel.
6.
Press plastic light wave guide from the front side into this hole.
7.
Attach your own handle.
8.
Attach the prepared custom front panel from behind with four wood screws and
four washers accordind to figure 1.
6
Turn on the PLATES setting. Signal light begins to flash immediately. Display
indicates 0:30. Close the drawer. Signal light stops flashing after 10s to 30s. Wait
five minutes. Open the drawer. The air in the drawer should be warm. DO NOT
place hand directly on drawer bottom, but you should be able to feel the heat
coming off the glass.
Custom front panel
Prepare and attach custom front
panel
Test the installation