Topcom DIABLO 150 User Manual
Page 5
Topcom Diablo 150/Twin/Triple/Quattro
5
Topcom Diablo 150/Twin/Triple/Quattro
ENGLIS
H
5.5
Direct access memory (Key 1,2,3)
The product has 3 locations (Key ‘1’, ‘2’ and ‘3’) where you can store a number under and dial it by
pressing and holding one of these keys in standby. The phone will automatically take the line and dial
the number which is stored under this key.
5.5.1 Programing the direct memory keys
Press the Memory
button short. Press and hold the Memory button
until the
-icon appears on
the display. Press and hold one of the 3 direct memory keys (Key 1,2 or 3) where you want to store the
number under until ‘Sx - _’ appears.
Î
Enter the telephone number you whish to store.
Î
Press
the Memory button
again to confirm.
Î
You will hear a confirmation tone and the next entry will
appear. To leave the direct memory programming, press the On-hook button
.
5.6
Mute function
It is possible to deactivate the microphone during a conversation. Now you can speak openly without
being heard by your correspondent. Press the Mute button
during a conversation. to deactivate or
activate the microphone.
5.7
Setting the volume
During a conversation you can set the volume by pressing the scroll button
. You can set the
volume between 1-5.
5.8
Paging
When you press the Paging button
on the base unit, the handset emits a ringing signal for 20 seconds.
This signal helps you find a lost handset. Press any key to stop the ringing on all handsets.
5.9
Flash button (R)
When you press the R button, also called flash or recall, the unit generates a line interruption (of 100 ms
or 250 ms). It gives you the possibility to use the special services of your telephone provider and/or to
transfer calls when you have a telephone exchange. You can change the flash time if needed (See
“Setting the Flash time” on page 6).
5.10
Turning handset ON/OFF
Press
and hold to turn off.
Press
for 2 seconds to turn back ON.
5.11
Programming procedure
You can change the ring melodie, volume, day, time etc... by going into the program procedure: To go
into the program procedure you have to press and hold the Program button
until the icon
starts to
flash.
Î
Press the Program button again to change the first setting. Each time you press the Program
button
you
will confirm the previous setting and jump to the next setting:
External ring volume/melody
Î
Internal ring volume/melody
Î
Date/time setting
Î
Dial mode setting
Î
Flash time setting
Î
Base ring volume/melody
5.11.1 Handset External melody and volume
Press and hold the Program button
until the icon
starts to flash.
Î
Press the Program button
again, the external melody is heard and the EXT-icon is flashing.
Î
Select the desired melody (1-5)
by entering a number (1 - 5).
Î
Use the scroll keys
to select the desired volume (Off or 1-5)
Î
Press
again to confirm the setting and to go to the next setting below.