Telit Wireless Solutions GM862-GPS - Manual (Page 7)

GM862-GPS Hardware User Guide
1vv0300728 Rev. 0 - 27/04/06
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 7 of 55
2.2 Turning OFF the GM862-GPS
The turning off of the device can be done in two ways:
• by software command (see GM862-GPS Software User Guide)
• by hardware shutdown
When the device is shut down by software command or by hardware shutdown, it issues to the
network a detach request that informs the network that the device will not be reachable any more.
The hardware unconditional shutdown does not issue this request and shuts down immediately the
device.
2.2.1 Hardware shutdown
To turn OFF the GM862-GPS the pin ON# must be tied low for at least 1 second and then released.
The same circuitry and timing for the power on shall be used.
The device shuts down after the release of the ON# pin.
TIP: To check if the device has powered off, the hardware line PWRCTL should be monitored. When PWRCTL goes
low, the device has powered off.