Toshiba Blu-Ray Disc Player BDX2000KU - Manual (Page 28)

28 EN
PLAYBACK
This function plays back approximately at 1.3 times the
normal playback while keeping the sound output. This
function is available only on discs recorded in the Dolby
Digital format.
1 During playback, press [MODE] repeatedly
until the Rapid playback setting appears.
2 Press [ENTER] or [s / B] to switch (1.3x), or
off.
3 Press [PLAY B] to return to normal playback.
You can adjust the picture quality.
1 During playback, press [MODE] repeatedly
until
appears.
2 Use [K / L] to select your desired item, then
use [s / B] to adjust the setting.
S Black level
You can adjust the black level setting to make the black
parts of the pictures as bright as you prefer. You can select
“On” or “Off”.
S Noise reduction (DVD-video only)
Reduces the noise of the playback picture.
3 Press [RETURN] to exit.
You can enjoy stereophonic virtual space through your
existing 2 channel stereo system.
1 During playback, press [MODE].
2 Use [K / L] to select your desired setting.
3 Press [RETURN] to exit.
Rapid Playback
“Off” : Plays back in normal speed.
“ ” : Plays back approximately at 1.3 times of normal
playback.
Note
• Picture adjustment and audio language setting
cannot be changed during this function.
• Virtual surround does not work during this function.
• This function may not work at some points on a disc.
• During this function, 2ch LPCM will be output from
HDMI OUT jack and DIGITAL OUT jack.
Adjusting the Picture
“On” : Enhances detail in darker areas.
“Off” : Shows the original picture as recorded.
Off
Black Level
Noise Reduction
On
Off
e.g.) DVD-video
“Off” : Shows the original picture as recorded.
“1”
: Executes 3D noise reduction which detects and
deletes the noise by comparing each picture
frames.
“2” : Executes MPEG noise reduction which reduces
the block noise and mosquito noise on the
subtitles on the movie.
“3” : Executes both MPEG noise reduction and 3D
noise reduction.
Note
• The setting will remain the same even if the unit is
turned to the standby mode.
• “Black Level” is not effective under the following
conditions.
- When the picture is output from HDMI OUT jack.
- When the picture is output from COMPONENT
VIDEO OUT jack with “Component Output” set to
“480p / 720p / 1080i”.
• You cannot adjust the setting during rapid playback.
Virtual Surround
“Off” : No surround effect
“1”
: Natural surround effect
“2” : Stronger surround effect
Note
• Set the virtual surround setting to “Off” or lower the
volume if the sound is distorted.
• Virtual surround does not function during rapid
playback.
• For the virtual surround, audio signal will always be
2-channel LPCM.
Off
E5PJ1UD_EN.book Page 28 Thursday, September 10, 2009 6:45 PM