Toshiba 27AX61 - Manual (Page 14)

12
POWER
1 2 3
4 5 6
7 8 9 0
TV VCR CABLE
CH RTN
ENT
100
CH +
CH –
FAV EXIT RECALL TV/VIDEO
CODE MTS SLEEP MUTE
RESET CAP/TEXT 1/2
MENU/
ENTER
VOL
FAV
VOL
+ –
STILL LOCATE SWAP PIP
PIP CH PIP CH
Adding channels to the TV’s memory
Your TV will stop on specific channels that are stored in the TV’s
channel memory when you press Channel + or –. Use the steps below
to set all active channels in your area automatically.
Programming channels automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory, you
can erase channels or add your favorite channels.
To add channels:
1. Press MENU, then press or to display the SET UP menu.
2. Press
▲ or ▼ until the TV/CABLE
selection is highlighted.
3. Press or to highlight either
TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press ▼ to select CH PROGRAM.
5. Press or to start channel programming. The TV will automati-
cally cycle through all the TV or Cable channels (depending on
which you selected), and store all active channels in the channel
memory.
While the TV is cycling through the channels, the message
“PROGRAMMING NOW PLEASE WAIT” appears.
6. When channel programming is complete, the message “COMPLETED
(channel or cable number)” appears.
7. Press Channel ▲ or ▼ to view the programmed channels.
Adding and erasing channels manually
After you’ve programmed the channels, you can add or erase specific
channels.
To add or erase channels:
1. Select the channel you want to add or erase using Channel + or –.
If adding channels, you must select the channel to add by using the
Channel Number buttons.
2. Press MENU, then press or
to display the SET UP menu.
3. Press ▲ or ▼ to highlight ADD/
ERASE.
4. Press or to select ADD or
ERASE, whichever function you
want to perform.
5. Repeat steps 1-4 for other
channels you want to add or erase.
Changing channels
To change the channel, you can:
• change the programmed channels using the remote control
• select a channel directly using the remote control
• scan the channels using the TV buttons
To change to the next programmed channel:
Press Channel + or – on the TV or remote control.
To change to a specific channel (programmed or unprogrammed):
Press the Channel Number buttons (0-9 and 100).
For example, to select channel 125, press the 100 button, the 2
button, and the 5 button.
Setting up
your TV
PICTURE AUDIO SET UP OPTION
CH
CH PROGRAM
ADD / ERASE
START
ADD
SELECT ADJUST
TV / CABLE TV CABLE
PIP SOURCE TV
PICTURE AUDIO SET UP OPTION
CH
CH PROGRAM START
SELECT ADJUST
TV / CABLE TV
ADD / ERASE ADD ERASE
PIP SOURCE TV
Menu
Exit
Channel +/–
POWER
1 2 3
4 5 6
7 8 9 0
TV VCR CABLE
CH RTN
ENT
100
CH +
CH –
FAV EXIT RECALL TV/VIDEO
CODE MTS SLEEP MUTE
RESET CAP/TEXT 1/2
MENU/
ENTER
VOL
FAV
VOL
+ –
STILL LOCATE SWAP PIP
PIP CH PIP CH
Menu
Exit
Channel
Numbers
Channel +/–
3K10501A P12-21 7/4/01, 2:55 PM 12