Toastmaster TCO2B - Manual (Page 3)

3
FIGURE 1
FIGURE 2
Lever
Guide
Bar
Geared
Wheel
Cutting
Blade Cord
Storage
FIGURE 3
Pivot Hole
Pivot
FIGURE 4
USING THE CAN OPENER
See CARE AND CLEANING for assembly instructions.
1. Remove all packaging materials before using.
2. Place the can opener on a level surface and plug into 120V~60 Hz
electrical outlet.
3. Hold can approximately level.
4. Raising lever, place can under guide bar and against geared wheel, see
Figure 1.
5. Press down on lever to pierce lid of can. This also starts the cutting
action. Let go of lever and can will stop automatically when opened.
6. Grasp the can, then raise the lever up from the can.
7. Slide the lid away from the magnet. Use caution to avoid injury from
sharp edge of lid.
HINT FOR USING THE CAN OPENER
•
To open extra tall cans, place can opener at edge of counter before
wedging can in position for opening.
Do not use the can opener for more than 5 minutes at a time. Allow to cool
for at least 15 minutes before using. This will prevent motor burnout due to
overheating.
CARE AND CLEANING
Unplug the unit from electrical outlet.
1. To remove lever, hold the can opener facing you. Lift the lever upward to
the highest position (as shown in Figure 1) and push the lever to the
right.
OPERATING INSTRUCTIONS
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
TCO2/TCO2B Can opener E/F/S(Ref 1/10/01 5:02 PM Page 3