Telit Wireless Solutions GM882 - Manual (Page 36)

36
from abroad, the calls Originated by your mobile; all the international
outgoing calls or all the international outgoing calls except for the calls towards
your home country. The entry Clear all allows you to clear all filters, and so
make and receive any type of call. Change code allows you to change the
security code you have to insert before working on Barring functions.
Divert (menu 3-6) allows you to divert incoming calls to another phone number.
You can select to divert All calls, only Missed calls, the calls with No reply,
calls received while your phone was Not reachable, calls received while you
are busy, or all calls except those in the last 3 categories.
Send number (menu 3-7) allows you to decide if you want your number to be
viewed on the display of the phone you are calling. The first entry of the menu
– Predefined – uses the default setting of the network. With the second entry
your number will be shown each time you call, whereas with the third entry it
will not be shown.
N.B. independently of the setting of this function, SMS messages will ALWAYS
show the sender’s number.
Calls control (menu 3-8) allows you to enable a sound signal every 60
seconds during a conversation in order to check its length.
Settings (menu 4)
The functions you can access through this menu entry allow you to set and
regulate the various modes of phone functioning, from the ringing tones to the
screen brightness, from the SMS tone volume to the management of security
codes.
From the menu entry Display (menu 4-1) you can access the parameters
related to the screen and display.
You can set, in order, the Contrast (4-1-1) of the display, the Brightness
(4-1-2) and the Bright time (4-1-3) of the backlight.
The Gm882 is equipped with a Screen saver (4-1-4), that you can choose
from those available, which shows an image on the display if no keys have
been touched for a certain length of time (to set this, enter menu 4-1-4-3
Waiting time)
Use the function Select (menu 4-1-4-1) to choose the Screen saver from
those available (move the joystick up and down to view them, press it to
select the one you want, then go back to the menu by pressing

).
Select the entry Enable (4-1-4-2) to enable or disable the Screen saver
function.
The entry Delay allows you to decide how long the phone has to wait
before acticvating the screen saver.