Thermos The Big Easy Quickset Traditional LP Gas Grill - Manual (Page 24)

24
Cleaning The Rotisserie Burner
Follow these instructions to clean and/or replace parts or if you have trouble igniting
the Rotisserie burner.
1. Turn gas off at control knobs and LP tank.
2. Disconnect ignitor wire from electrode (A).
3. Remove thumbscrew from shield (B), remove shield and clean any accumulation of grease
with soap and water.
4. Unfasten hinge pins and hitch pin. Note how hinge pins and hitch pins are attached.
5. Using garden hose (preferably with nozzle), force water through burner tube. Make
sure water comes out of every burner porthole. Open clogged portholes with thin wire.
6. Examine rotisserie housing and burner closely (C). If any cracks or large holes (other
than portholes) are found replace rotisserie burner.
7. Wipe ceramic portion of electrode (A) with rubbing alcohol and cloth.
8. If grill is to be stored, coat burner lightly with cooking oil. Wrap with protective cover to keep
insects out.
9. After burner has been cleaned, place rotisserie burner onto back of grill bottom and attach
with hinge pins and hitch pins.
10. Place gas tube inside burner tube put shield over burner tube and secure with thumbscrew.
VERY IMPORTANT: Burner tube must engage gas tube as shown (D).
11. Attach flat end of ignitor wire (A) to electrode.
Gas Tube
Burner Tube
BACK OF GRILL
Rotisserie Burner
Gas Tube
Thumb Screw Shield
Ignitor Wire
Burner Tube
Burner Portholes
Burner
Tube
Housing
Hitch Pin
Hinge Pin
Hitch Pin
Hinge
Pin
Electrode
A
B
C
D