Toshiba TDP-ET20 - Manual (Page 21)

CONTENTS 21
Operations
Picture projection
CAUTION
Do not look into the projection lens while
operating the projector.
Preparation
• Install and connect the projector properly.
• Take off the lens cover.
• Set the POINTER/PJ to “PJ”.
Press ON/STANDBY.
Both the ON and LAMP indicators light up
in green.
Turn on the connected
equipment and put it in
playback mode.
1
2
3
(Continued)
Select the input source.
(On the remote control)
Press RGB or VIDEO.
(On the control panel of the main unit)
Press INPUT repeatedly.
Each time the button is pressed, the
source indication on the screen changes
as follows:
RGB: To project pictures from a
computer connected to RGB
INPUT.
Video: To project pictures from a
video player connected to
VIDEO INPUT.
Camera: To project pictures from a
document imaging camera.
(For document imaging
camera model only)
Adjust the picture size by
turning the zooming ring.
Turn to the right to enlarge the picture.
Turn to the left to reduce the picture.
Focus on the picture by
turning the focusing ring.
A still picture is recommended for
focusing.
→
→→
4
5
Indicators 3
5 4
ON/STANDBY MENU ENTER
SELECT/ADJUST
INPUT
ON
LAMP
TEMP
1
AUTO SET
POINTER
PJ
MARKER LASER
MENU ENTER
KEYSTONE
ON/STANDBY
R-CLICK L-CLICK
VIDEO CAMERA RGB
RESET FREEZE RESIZE
1
3
On (Green)
Flashing (Green)
On (Green)
On (Green)
LAMP
ON
LAMP
ON