Transcend Information 720 - Manual (Page 36)

NOTE:
The T.photo always preserves the original aspect ratio of all images based on each picture file’s orientation
information (EXIF), and NEVER stretches them to fill the entire screen. An easy, distortion-free way to
remove the black bars from the top/bottom or sides of an image is to use the Fullscreen option mentioned
above, or the Zoom function. The way photos are displayed depends on the T.photo’s orientation (see graph
below)
Detected Photo
Type (EXIF)
Horizontal Vertical
Fullscreen
Mode
T.photo
Orientation
Disabled Enabled Disabled Enabled
Landscape (A)
Portrait (B)
Restore Defaults
This function is available if you want to reset your T.photo’s settings. Note: All settings that have been
changed will return to the factory defaults.
1. Select Restore defaults from the Settings menu.
2. Use LEFT or RIGHT to highlight “Yes.”
3. Press to confirm.
4. After the process is finished, the Settings menu will be displayed again.
Upgrade Firmware
Use this function to keep your T.photo up to date with the latest version from Transcend (available on the
Transcend website.
1. Insert a storage device such as a USB flash drive or SD/SDHC/MMC/MS/CF memory card that
contains a newer version of firmware.
2. Select Firmware upgrade from the Settings menu and press to start the firmware detection
process. T.photo will automatically find the new firmware file.
3. If T.photo finds that a newer version of firmware is available, a “Yes / No” selection message will be
shown. Use LEFT or RIGHT to select “Yes” and press to perform the system upgrade. If you
do not want to upgrade, press “No” to return to the Settings menu.
35