Tektronix Grass Valley 3000 - Manual (Page 85)

2-49
Configuring External Interfaces
Configuring the Peripheral Interface
The Peripheral Interface Menu allows you to set up the
parameters for the Peripheral Bus II port (A3).
1. From the Configuration Menu, press EXTERN I/F> , then
PERIPHERAL I/F> to bring up the Peripheral Interface Menu.
2. Select the baud rate and parity parameters for the Peripheral
Bus II port interface by incrementing to the desired settings.
These should be set to be the same for the Model 3000 and the
peripheral device. For a DPM-700, set the baud rate to
38400
and parity for NONE .
PERIPHERAL INTERFACE MENU
config / extern if / peripheral if
PERIPHERAL
TRIGGERS >
NOTE:
The Peripheral Bus port is labelled
"Port A3" on the rear of the frame
electronics.
EVEN
PARITY BAUD
38400
ODD
NONE
2400
4800
9600
19200