TOYOTA pmn - Manual (Page 35)

35
(j) Place the undercover on the floor (engine side facing
down)
(k) Remove drain plug cover.
(l) Prepare the template.
K: Template (27-1)
(m) Fix the template onto the undercover with tape.
(n) Mark the position where to cut with a marker.
(o) Mark the 6 hole positions into the undercover.
(p) Remove the template.
(q) Pre drill 6 holes of 4mm.
(r) Drill the 6 x 11.2 mm holes into the undercover.
(s) Cut the marked position out of the undercover with a
cutting tool.
U
K
Ø 4 mm
6x
Ø 11,5 mm