Toshiba SD-43HK - Manual (Page 24)

Troubleshooting
45
• The power cord is disconnected. • Plug the power cord into the wall outlet
securely. No power.
• No disc is inserted. • Insert a disc. (Check that the DVD or,
audio CD indicator in the display
window is lit.) The power is on, but
the DVD receiver
does not work.
• The TV is not set to receive DVD
signal output. • Select the appropriate video input mode
on the TV so the picture from the DVD
receiver appears on the TV screen.
• The video cable is not connected
securely. • Connect the video cable into the jacks
securely.
No picture.
• The equipment connected with the
audio cable is not set to receive DVD
signal output. • Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD receiver.
• The audio cables are not connected
securely. • Connect the audio cable into the jacks
securely.
• The power of the equipment connected
with the audio cable is turned off. • Turn on the equipment connected with
the audio cable.
• The Digital Audio Output is set to the
wrong position. • Set the Digital Audio Output to the correct
position, then turn on the DVD receiver
again by pressing On/standby( ).
No sound.
• The disc is dirty. • Clean the disc. The playback
picture is poor.
• No disc is inserted. • Insert a disc. (Check that the DVD, or audio
CD indicator in the DVD display is lit.)
• An unplayable disc is inserted. • Insert a playable disc. (Check the disc
type, color system and Regional code.)
• The disc is placed upside down. • Place the disc with the playback side
down.
• The disc is not placed within the guide. • Place the disc on the disc tray correctly
inside the guide.
• The disc is dirty. • Clean the disc.
• The Rating level is set. • Cancel the Rating function or change
the rating level.
The DVD receiver
does not start
playback.
• The remote control is not pointed at the
remote sensor of the DVD receiver. • Point the remote control at the remote
sensor of the DVD receiver.
• The remote control is too far from the
DVD receiver. • Operate the remote control within about
23 ft (7 m).
• There is an obstacle in the path of the
remote control and the DVD receiver. • Remove the obstacle.
• The batteries in the remote control are
exhausted. • Replace the batteries with new ones.
The remote control
does not work
properly.
Symptom Cause Correction
• The connected TV power is turned off. • Turn on the TV.
MISCELLANEOUS
46
Check the following guide for the possible cause of a problem before contacting service.
Language Code List
Enter the appropriate code number for the initial settings “Disc Audio”, “Disc Subtitle”
and/or “Disc Menu” (See page 32).