Toshiba SD-W1111 - Manual (Page 3)

OD-A017-02
TOSHIBA DVD-RAM SD-W1111 ‘99/06/26 Version 1.0
Page 3 Product Specification
Precaution
This equipment (an optical disc drive) handled under the conditions out of product specifications may
cause injury, heat generation, trouble, erroneous operation and performance degradation, so, care will be
necessary, and proper handling according to the precautions shown below will be required. In case of
mishandling without keeping the cautions, safety, reliability and performance of the product are not
guaranteed. For systems using this equipment, please note it above mentioned on manuals etc. to
understand the users completely.
Cautions
(1) Don’t loosen screws except persons trained with specified instructions. The reliability, safety and
performance specified in this specification can not be satisfied.
(2) Don’t modify this equipment. The reliability, safety and performance specified in this specification can
not be satisfied.
(3) Don’t insert any objects or cartridge other than specified from the cartridge insertion slot. It may cause
trouble or erroneous operation.
(4) Don’t give excessive vibration and shock this equipment. It may cause trouble or erroneous operation.
(5) Toshiba Corporation makes no warranty of any kind, either expressed or implied, including, but not
limited to, the implied warranties of merchantability and fitness for a particular purpose. This product
may sustain damages which may cause errors and failures. The causes are not confined to what are
mentioned or implied in this document. Therefore, the possibilities of error and failure should be taken
into consideration when furnishing systems should be protected by such means as system backup and
mirroring disk subsystem, especially when this product is used for systems as medical appliances.
Toshiba Corporation shall not be liable for incidental or consequential losses or damages to tangible
property, injury or death of person in connection with the errors and failures which may occur when
furnishing, operating or using this product
(6) When a disc cannot be ejected because of some troubles, etc., turn off the power for this equipment and
eject the disc using the emergency eject mechanism after passing more than 1 minute. When the
emergency eject is carried out while the power is on or immediately after the power off, the disc may be
ejected in a rotating status. Toshiba Corporation does not assure if the disc is damaged by this.