Troy-Bilt 70 - Manual (Page 6)

6
Figure 3-1
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right and left hand side of the Chip-
per/Shredder Vacuum is observed from the operating
position.
Opening Carton
1. Cut each corner of the carton vertically from top to
bottom.
2. Remove all loose parts.
3. Remove loose packing material.
Removing Unit From Carton
1. Lift unit from the rear to detach it from underlying
carton material and roll unit out of carton.
2. Check carton thoroughly for any other loose parts.
NOTE: Make sure not to crimp cables while removing
loose parts or the entire unit from the carton.
Loose Parts In Carton (See Figure 3-1)
a. Upper and Lower Handle
b. Hose Assembly
c. Safety Glasses
d. Engine Oil (May be located in bag)
e. Bag
f. Blower Chute (If Equipped)
g. Operator’s Manual
3
Setting Up
Your
Chipper
Shredder
Vacuum
NOTE: Reference to
right and left hand
side of the Chip-
per/Shredder Vacuum
is observed from the
operating position.
IMPORTANT
This unit is shipped
without gasoline or
oil in the engine. Be
certain to service
engine with gasoline
and oil as instructed
in the separate engine
manual before operat-
ing your machine.
Drive Control
Speed Control
Upper Handle
Bag
Hose
Assembly
Blower Chute
Carriage
Screw
Upper Hose
Handle Bracket
Rope Guide
Star Knob
Wing Nut
Cable Guide
Bottle of Engine Oil
Operator’s Manual
Safety Glasses
Lower Hose
Handle Bracket
Lower Handle
Wing Nut