TechniSat DIGITY CI Operating Manual - Manual (Page 13)

13
> Confirm by pressing OK. The menu LNB Settings
will be displayed. (Fig. 5-8)
The following settings can be effected in this sub-menu:
5.4.1 Switching DiSEqC on and off
DiSEqC ( Digital Satelliten Equipment Control) is a digital
switching signal used to control DiSEqC-compatible
components via the antenna connection.
If your external unit is equipped with DiSEqC componen ts
you must activate the DiSEqC switching:
>
In this line, use the OK key to switch the DiSEqC on
or off.
As only one LNB can be controlled when the DiSEqC
switching is not activated, the menu will be restricted
to the configuration of a single LNB.
5.4.2 Setting the switching matrix and the LNB
characteristics
The menu lists the four switching criteria of the DiSEqC
switching feature.
Your unit is pre-programmed so that ASTRA will be received
in switch position A/A and Eutelsat will be received on switch
position B/A of a multi-switch. Should the switching matrix of
your receiving installation be configured differently, or if you
wish to receive other satellites, you can adjust your receiver
to the parameters of your receiving installation as follows.
> Use the arrow keys up/down to select the DiSEqC
switch position (1-4) to which you wish to assign a
satellite, by marking this line in blue (e.g..
A/B 3 No
Satellite).
> Press
OK.
A table showing the satellites available for selection
will be displayed.
> Use the arrow keys up/down to mark the required
satellite.
Use the arrow keys up/down to move up or down the
menu one line at a time, use the arrow keys left/right
to move forward or back one page at a time.
Should the satellite you require not be listed, please
select one of the reserve slots, designated
User1 to
User 14.
> Confirm by pressing OK. The selected satellite will
now be inserted at the previously marked poosition in
the menu LNB Settings.
You should now proceed to work through the menu LNB
Settings, until the settings in this menu correspond with the
characteristics of your receiving installation. In the case of
any switching criteria you do not require, select the option
No Satellite.
(Fig. 5-8)
A B
Position
Output
A B
Position
Output
A B
Option
Output
Example:
bed_anl_DIGITY CI_Quark3_en.qxd 31.01.03 16:47 Seite 13