Toshiba W-609 - Manual (Page 38)

38
DSS ® Satellite Receiver Set-up (continued)
VCR display
6 Select “CONTROL” using PLAY or STOP, and set to “O n ” or
“OFF” using FF or REW.
O n : if your DSS ® satellite receiver is
remote-controllable.
• Satellite channels will be selected by
CH (CABLE BOX) on the remote
control.
The VCR can change the satellite
channel to the desired one when timer
recording starts.
→
Go to step 7.
OFF: if your DSS ® satellite receiver is
NON remote-controllable.
• Satellite channels will be selected by
the own channel selector of the DSS ®
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
® satellite
receiver.
→ Go to step 8.
7 Select “BRAND TYPE” using STOP, and enter a brand code
of your DSS
® satellite receiver using number buttons. Refer
to the table on the next page.
Example: For a TOSHIBA DSS ® satellite receiver, identified by
number 99.
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
®
satellite receiver on the VCR so that it can receive the infrared signal.
8 Press PROG. three times to exit.
Notes
• If your satellite channel does not change to 200 in step
7 , the DSS ® satetllite
receiver will not be able to change channels in the timer recording. In this
case, set “CONTROL” to “OFF” in step
6 .
• The VCRPlus+C system recording is not available on satellite channels.
• The DSS
® satellite receiver control is not compatible with the cable box
control.
3 ®
E n D : PROG
SET UP PRESET PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO n TROL Off on
BRA n D TYPE no. 36
E n D : PROG
SET UP PRESET PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO n TROL Off on
E n D : PROG
SET UP PRESET PROGRAM
USE no c. Box DSS
OUTPUT CH 3CH
CO
n TROL Off on
BRA n D TYPE no.99
SENDING A TEST SIGNAL
TO YOUR CABLE BOX
W-609/TSB DRAFT(24-40)01 26/11/99, 8:21 PM 38