Cabinet installation, Centerline hole dimensions for figures 10 and 11 – Thermador PH54 User Manual
Page 9
1.
In the base of the cabinet drill
1/8" tap holes (See Dimension
A in Figure 10 and in Table).
Screw in four #10 x 1" screws
(provided with hood) leaving 1/4"
exposed).
2.
If the hood is installed for
vertical discharge, use Figure 11
to create clearance holes for
passage of the transition and
conduit (See Dimension B in
Figure 11 and in Table).
3.
For horizontal discharge use
Figure 5 for the geometry of the
cutout required for clearance of
the transition.
4.
Hang hood from screws and
tighten securely.
5.
From inside of hood, insert
screws supplied. Drill through
holes (use #8 x 5/8" screws
supplied), one (1) on each side
and four along the front, into
bottom of the cabinet. See
screw holes labeled "L" in
Figure 10.
The hood can be installed under a
cabinet by supporting the hood
from the top.
Note: The cabinet must be
structurally joined to the wall
studs to support the weight of
this hood.
Figure 10 shows the four (4) screw
holes (K) used for mounting the
hood to the bottom of the cabinet.
Make sure both knockouts have
been removed.
Cabinet Installation
Centerline Hole Dimensions for Figures 10 and 11
{
Figure 10: Tap Hole and Screw Hole Locations
1
-9
/
16
"
7
-1
/
16
"
A: Tap Hole Locations
23"
K
K
L
L
L
HOOD
A (Fig 10)
B (Fig 11)
SIZE
Tap Holes
Conduit Hole
30"
29
-1
/
16
"
13
-7
/
16
"
36"
35
-1
/
16
"
16
7
/
16
"
42"
41-
1
/
16
"
19
-7
/
16
"
48"
47
-1
/
16
"
22
-7
/
16
"
54"
53
-1
/
16
"
25
-7
/
16
"
Note: This figure depicts tap hole and
screw hole locations only. See Figure1b,
Page 4 for overall hood dimensions.
Figure 11: Transition and Conduit Locations
23"
3 -3/16"
7 7/8"
2 3/8"
Wall
B
1 -1/8"
1- 7/8"
2 -3/8"
Cooktop
Centerline
Plan View of Cabinet Cutout
5/8" DIA clearance
holes for 1/2" conduit
to j-box.
Note: This figure depicts transition and conduit locations only. See Figure 1b,
page 4 for overall hood dimensions.
8