Topcom BUTLER 2511 Deluxe - Manual (Page 83)

Topcom Butler 2511 Deluxe 83
ENGLISH
- Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and
green LED will lit ones.
- Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover
from the headset so that the registration key hole is free also.
- Press the headset registration key. The red LED will flash rapidly.
-
If after a few seconds the green LED flashes slowly, the registration is successful.
- If the red LED flashes slowly, the registration is failed. Repeat above procedure and make
sure that the base pin-code is set to ‘0000’!
6.5 SELECTING A BASE
The handsets can be registered up to 4 bases simultaneously.
To select a base:
1.
Enter the menu by pressing /OK
2. Select setup using the up and down keys
3. Press OK
4. Select SEL BASE using the up and down keys
5. Press OK
6. Select a base or select AUTO using the up and down keys
7. Press OK
When selecting the base, the currect selected base in indicated by a ‘o’ sign after the base number. If you select ‘Auto’
the handset will automatically search for another base when you are out of range!
7. TROUBLE SHOOTING
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the batteries
Recharge the batteries
Handset turned OFF Turn ON the handset
No tone Telephone cord badly connected Check the telephone cord connection
The line is occupied by another handset Wait until the other handset hangs up
The icon flashes Handset out of range Bring the handset closer to the base
The base has no power supply Check the mains connection to the base
The handset is not registered on the
base Register the handset on the base
Base or handset do not ring The ringing volume is zero or low Adjust the ringing volume
Tone is good, but there is no
communication The dialling mode is wrong Adjust the dialling mode (pulse/tone)
Not possible to transfer a call on PABX The FLASH time is too short Set the unit to Long Flash time
Telephone does not react to pressing the
keys Manipulation error Remove the batteries and put them back
in place
HL_B2511.book Page 83 Friday, October 17, 2003 12:32 PM