Technicolor - Thomson Thomson Lyra PDP2335 - Manual (Page 8)

EN EN
7
Before You Begin
Using Headphones
Insert phone plug into the headphones
jack ( ) on the back of player for
listening.
Have a Blast- Just Not in Your Eardrums.
Make sure you turn down the volume on
the unit before you put on headphones.
Increase the volume to the desired level
only after headphones are in place.
How to Use Your Clip Phones
(The e.clipz)
The right ear clip phone is labeled R
while the left ear clip phone is labeled L.
1. Pull the ear hook away from the ear
pad slightly. You will hear a click
sound.
2. Slide the ear hook behind the ear with
the ear pad on the front of the ear.
Rotate the clip phone so the ear pad
fits closely with the ear.
3. Lock the clip phone in place by
pushing down on the top of the ear
hook until it locks.
4. For best sound quality, make sure the
earpad fits closely with your ear.
L R
CLICK CAUTION
DO NOT INSERT EAR HOOK INTO
YOUR EAR.
Before You Begin
Insert battery into the
player
1. To insert batteries, press the PUSH
OPEN button next to the battery door
to release the lock and lift the door.
2. Insert a “AA”(UM3) battery with
polarities corresponding to the
indications on the compartment.
(Refer to “Before You Begin” for
important battery information.)
3. Close the door to the battery
compartment.
Inserting a SD card /
MultiMediaCard (Optional)
The player has built-in flash memory. To
extend the playtime, you can use the
optional Memory Card slot.
1. Insert a Memory Card into the card slot
on the top of the player when it is off
as illustrated in the diagram below.
2. To remove the card, pull the Memory
Card out when the unit is off.
Note
Refer to the power level indicator on
display for battery level.
Replace with new batteries when the
indicator is empty. Refer to “Display
Overview” on page 11.
Note
Do not remove the Memory Card
during playback or when the power is
on. This may stop the unit from
playing immediately or damage the
memory on the memory card or the
player.
6
MEMORY CARD
Top View
PU SH O P E N
PDP2325_35 EN 16_4 4/26/04 3:02 PM Page 16