Tascam 302mkII - Manual (Page 13)

TASCAM 302MKII
13
A maximum of ten compatible units (TASCAM 322 or
302MkII) can be interconnected to provide the
following possibilities :
“ Sequential link play of multiple cassettes.
“ Dubbing onto multipie cassettes simultaneously.
“ Recording an external source onto multiple
cassettes simultaneously.
WARNING : Make all conncctions with power off.
Each time one cassette plays up to the end of the
reverse tape side, the next cassette will start.
1. Check to see that all the units are turned off.
2. Refer to the diagram above, and connect the first
units EXT CONTROL OUT to the second units
EXT CONTROL IN, the second units EXT
C O N T RO L O U T t o t h e t h i r d u n i t s E X T
CONTROL IN, and so on. Finally, connect the last
units EXT CONTROL OUT to the first units EXT
CONTROL IN.
3. Switch on power to all the units.
4. Make the following switch settings on each unit :
“ OFF/SLV/MSTR switch to OFF ;
“ REV MODE switch to CONT .
5. Insert pre-recorded tapes into decks 1 and 2 of
every unit.
6. To start sequential link play, press PLAY on either
deck of any unit.
7. To stop play, press STOP on the deck which is
currently in play.
NOTE
If there is a slave unit which has no tape inserted,
sequential link play will stop when this slave is
detected.
Sequential Link Play
Multiple-Unit System Operation