Topcom FIDELITY 1150 - Manual (Page 9)

Topcom Fidelity 1150 9
Topcom Fidelity 1150
ENGLIS
H
14.4 To delete an OGM
14.5 TAD Setting
14.5.1 Selecting OGM1 or OGM2
In of the TAD setting menu, you can also select
the outgoing message.
14.5.2 Select the number of rings
To select the number of rings before the TAD an-
wswers the call:
14.5.3 Setting the remote PIN code
This code is necessary for remote operation (see
chapter 14.11)
14.5.4 Call Screen Mode
When there is an incomming call you can listen to
the recording without picking up the handset.You
can enable or disable this function.
If the OGM is less than 3 seconds, the recording
is not valid.
To stop the recording. The message
will be playbacked
To replay the recorded OGM
Select OGM1 or OGM2.
To replay the recorded OGM
Press the delete button during
playback. The pre-recorded message
is prompted
Enter the menu
Select ‘TAD Setting’
Enter the submenu
Select ‘Answering’
To confirm
Select ‘Answering-A1’ (OGM1) or
‘Answering-A2’ (OGM2)
Confirm
ESC 2 X To leave the menu
Enter the menu
Select ‘TAD Setting’
Enter the submenu
Select ‘TAD Rings’
To confirm
Select 2 to 9 or select T/S
Confirm
ESC 2 X To leave the menu
T/S is ‘Toll Saver’. The TAD will answer a call
after 4 rings if there are no new messages, and
after 2 rings if there are new messages. If there
are no new messages and you call your
machine to check your messages remotely, you
can hang up after the 2nd ring. You do not need
to pay connection fees and you know that you
do not have any new messages.
Enter the menu
Select ‘TAD Setting’
Enter the submenu
Select ‘TAD Pin’
To confirm
Enter the new PIN code (3 numbers)
Confirm
ESC 2 X To leave the menu
Enter the menu
Select ‘TAD Setting’
Enter the submenu
Select ‘Call Screen’
To confirm
Select ‘Call Screen - On’ or ‘Call
Screen - Off’
Confirm
ESC 2 X To leave the menu