Toshiba 36A12 - Manual (Page 29)

29
Ref
er
ence
W
elcome to Toshiba
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V’s
F
eatur
es
Appendix
Index
Changing the location of the PIP window
With the TV in PIP mode, press LOCATE to change the location of
the PIP window on-screen. Every time you press LOCATE, the PIP
window changes position counter-clockwise.
Freezing the PIP display
With the TV in PIP mode, press STILL to freeze the PIP display. The
PIP picture becomes still, and is outlined in red on-screen. Press
STILL
again to restore the moving picture (outlined in green).
Still
Watching multi-window PIP
Multi-window PIP appears as six small boxes across the bottom of the
screen. The multi-window PIP displays only the channels you
programmed into the TV’s memory (see “Adding channels to the TV’s
memory” on page 17).
Note: The LOCATE, SWAP, PIP CHANNEL
yz , SOURCE,
and STILL buttons do not function in multi-window PIP mode.
To view multi-window PIP:
Press PIP three times.
The TV cycles through all of the programmed channels, showing a
few seconds of each channel’s programming, and then freezes the
image and moves on to the next channel in a continuous cycle. The
channel number appears above each PIP window.
A
14 23 27 30 43 56
To turn multi-window PIP off:
Press PIP again, or change the channel.
Note:
Multi-window PIP displays channels
programmed for the signal source you are
currently viewing (ANT-1 or Cable).
ADV/
PIP CH
ADV/
PIP CH
ENTER
PLAY PIP
REC
STILL LOCATE SWAP
TV/VCR REW FF
STOP SOURCE
FAV FAV
C.CAPT
EXIT
MENU
RESET
SWAP
PIP CH
CT-9946
SOURCE
PIP
STILL
LOCATE
X
Note:
If V-Chip blocking is enabled when
you view multi-window PIP, channels
exceeding the rating limits will appear
as a black window with a red “X.”