Hardware setup and driver installation, Hardware setup – Transcend Information 3-in-1 Card Reader/Writer TS0MFLRD User Manual
Page 4
Advertising
2
Hardware Setup and Driver Installation
Follow the steps below to install the 3-in-1 Card Reader/Writer and driver for
the first time.
Hardware Setup
In Windows 98/98SE, the driver must be installed before
hardware setup.
1.
Plug the “device end” of the USB cable into the 3-in-1 Card Reader/Writer,
and connect the other end of the USB cable into the USB port of the
computer (as shown in the figure below).
2.
Refer to the following instructions to install the appropriate driver and begin
using the 3-in-1 Card Reader/Writer.
Advertising