Toshiba Hi-Fi VCR & DVD Video Recorder D-VR5SU - Manual (Page 21)

Introduction
21
Connect to a TV with HDMI output
HDMI stands for High Definition Multimedia Interface. HDMI transfers digital audio and uncompressed digital
video on a single cable. As a result, audio cables and video cables don’t need to be connected separately to a
device. In addition, HDMI is compatible with HDCP (High Bandwidth Digital Content Protection).
HDMI Cable (not supplied)
HDMI-compatible
display
To HDMI input
To HDMI OUT
Connections with the TV or audio component
For proper operation, it is recommended that you use
as short an HDMI cable as possible.
Notes:
• Refer to the owner’s manual for the TV to be connected to this recorder for more information concerning
HDMI connections.
• HDMI is an evolving technology, so it is possible that some devices may not operate properly with this recorder.
• No sound will be output from the HDMI OUT jack if the “DOLBY DIGITAL OUTPUT” is not set to “PCM” (see
page 32).
Switching the output signals (HDMI/Progressive)
1. Turn ON the TV and set to the appropriate input mode (HDMI or Component).
2. Press PROG/HDMI on the remote control to change the video output signals (HDMI/Progres-
sive) as below.
The content of the output for each ouput jacks are as shown in the following table and differ
depending on output setting.
* When the HDMI/Progressive is active, it is impossible to output any video images from the Video out jack and
S-Video out jack. In this case, press PROG/HDMI repeatedly to switch the HDMI/Progressive output setting to
“OFF” or set the TV to Component input mode/HDMI input mode.
Mode
VCR/DVD HDMI Video S-Video Component
OFF - 480i 480i 480i
480p 480p - * - * 480p
720p 720p - * - * 480p
1080i 1080i - * - *
480p
OFF - 480i 480i 480i
480p 480p 480i - 480p
720p 720p 480i - 480p
1080i 1080i 480i - 480p
DVD
VCR
Content of output for each output jack
HDMI/Progressive
Output setting
Notes:
• PROG/HDMI button is not available during VCR mode.
• 720p and 1080i are available when the unit is connected to the HDMI-compatible display.
• When the HDMI mode is active, the HDMI indicator “HD” on the display window will light up.
• If the HDMI cable is disconnected when the HDMI mode is active, the HDMI indicator “HD” on the display
window will flash. In this case, press PROG/HDMI repeatedly to switch the HDMI output setting to “OFF”, or
connect the HDMI cable again.
• When the progressive mode is active, the Progressive indicator “ P ” on the display window will light up.
• When the HDMI mode is active, you cannot use Dubbing function (see pages 78 and 79).
• If your TV is not compatible with progressive scan, press and hold the STOP button on the front panel for
about 3 seconds to return to normal picture.
HDMI Component
OFF 480i (Interlace)
480p (Progressive) 480p (Progressive)
720p (Progressive) 480p (Progressive)
1080i (Interlace) 480p (Progressive)
2J40101A P12-22 3/4/06, 10:43 AM 21