Topcom 2010 - Manual (Page 4)

4
TOPCOM Digital Baby Scale 2010
3 Description
1. LCD display
2. MEMORY - button
3. ON/OFF - TARA Button
4. MODE - Button
4 Simple operation
• Press the ON/OFF - TARA - button (3). The LCD display will show all segments for 2 seconds
before entering weight mode.
• Press the MODE - button (4) to select ‘Kilogram (kg)’ or ‘Pound (lb)’
• Gently place the baby on the pan.
• The babies weight (maximum 20Kg) flashes on the display after a few seconds.
• If the baby remain lying on the pan after its weight is shown, the value will continue to flash for 5
minutes and then turn off automatically.
• Press and hold the ON/OFF - TARA - button (3) for a few seconds to turn the scale Off or it will turn
off automatically in idle mode after 60 seconds.
5 Memory
You can store the last result in the memory for later review.
•
When the weight flashes on the display, press the MEMORY - button (2). ‘SET’ will be briefly
displayed.
To recall the weight:
•
While the scale is in "0.00" situation, press the MEMORY - button (2).
• The stored weighing value saved in the memory and the ‘MEM’ icon is displayed.
• Press the MEMORY - button (2) again to leave the memory function.
6 Error messages
Lo
Err
O_ld
Low power - Replace the batteries
Error during initialisation or measurement. Turn the scale off and on again and make
a new measurement.
Overload. The weight of the baby is over 20kg.
1 2 3 4
If you use a towl to lay the baby on, it should be placed on the pan before switching
on. If you forgot to do so, press the ON/OFF - TARA button to eliminate the weight
of the towl immediatelly after you have layed down the towl.
If you remove the towl, the scale will display a negative reading.