Toro 5400-D - Manual (Page 23)

23
4. Remove each end check plug and add enough lubricant
to bring the level up to the bottom of each check plug
hole.
5. Install all plugs.
Checking Reel to Bedknife
Contact
Each day before operating, check reel to bedknife contact,
regardless if quality of cut had previously been acceptable.
There must be light contact across the full length of the reel
and bedknife (refer to Adjusting Reel to Bedknife in
Cutting Unit Operator’s Manual).
Checking the Torque of the
Wheel Nuts
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Torque the wheel nuts to 75–80 ft.-lb. after 1–4
hours of operation and again after 10 hours of
operation. Torque every 250 hours thereafter.
Warning