Telit Wireless Solutions GE863-QUAD - Manual (Page 58)

GE863-QUAD
GE863-PY
1vv0300715 Rev. 1 - 19/09/06
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 58 of 79
11.1.2 Enabling DAC
An AT command is available to use the DAC function.
The command is AT#DAC[=<enable>[,<value>]]
<value> - scale factor of the integrated output voltage (0..1023 - 10 bit precision)
it must be present if <enable>=1
Refer to SW user guide or to GE863-QUAD / PY AT commands specification for the full
description of this function.
NOTE: The DAC frequency is selected internally. D/A converter must not be used during
POWERSAVING.
11.1.3 Low Pass Filter Example