Toshiba SATELLITE M500 User Manual

Page 16

Advertising
background image

16

5.375 x 8.375 ver 2.3

TOSHIBA is not responsible for any radio or television interference caused by
unauthorized modification of the devices included with this equipment, or the
substitution or attachment of connecting cables and equipment other than
specified by TOSHIBA.

The correction of interference caused by such unauthorized modification,
substitution or attachment will be the responsibility of the user.

The total radiated energy from all the antennas connected to the Wireless WAN
adapter, the Bluetooth® module, and the Wireless LAN cards conforms to the
FCC limit of the SAR (radio frequency exposure) requirement regarding 47 CFR
Part 2 section 1093.

Exposure to Radio Frequency Radiation

The radiated output power of the TOSHIBA Wireless WAN Card is far below
the FCC radio frequency exposure limits. Nevertheless, the TOSHIBA
Wireless WAN Card shall be used in such a manner that the potential for
human contact during normal operation is minimized. The antenna(s) used
for this transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter. Antenna(s) used in 5.15 GHz to 5.25 GHz
frequency band must be integral antenna which provide no access to the end
user.

Regulatory Information

The TOSHIBA Wireless WAN Card must be installed and used in strict
accordance with the manufacturer’s instructions as described in the user
documentation that comes with the product. This device complies with the
following radio frequency and safety standards.

CE Compliance

CE Compliance does not apply to systems with Wireless WAN (3G) modules
installed.

Canada – Industry Canada (IC)

Wireless WAN complies with RSS-129, RSS-133 Industry Canada.

The installer of this radio equipment must ensure that the antenna is located
or pointed such that it does not emit RF field in excess of Health Canada
limits for the general population; consult Safety Code 6, obtainable from
Health Canada’s Web site www.hc-sc.gc.ca/rpb. The RF device shall not be
co-located with any other transmitter that has not been tested with this
device.

Advertising