Toshiba IK-WB16A-W - Manual (Page 19)

19
l
When using a non-PoE switch
Use a PoE power injector to connect between the Network Camera and a non-PoE
switch.
4 3 2 1
WP S/R ES ET mic roS D
POWER COLLISION LINK RECEIVE PARTITION 1 2 3 4 5
l
When using a PoE switch
The Network Camera is PoE-compliant, allowing transmission of power and data
to both run in a single Ethernet cable. See the following illustration to connect the
Network Camera to a PoE switch via Ethernet cable.
4 3 2 1
WP S/R ES ET mic roS D
POWER COLLISION LINK RECEIVE PARTITION 1 2 3 4 5
PoE switch
(not supplied)
Non-PoE switch
(not supplied)
PoE power injector
(not supplied)
Power over Ethernet (PoE) (IK-WB16A only)
For this connection method, the
AC adapter is not used.
For this connection method, the
AC adapter is not used.