Toshiba DISC BDX2250KU - Manual (Page 10)

10
Operating with the remote control
* Do not expose the remote sensor of the Blu-ray Disc™
player to a strong light source such as direct sunlight
or other illumination. If you do so, you may not be able
to operate the Blu-ray Disc™ player via the remote
control.
Notes:
• Direct the remote control at the remote sensor of the
Blu-ray Disc™ player.
• When using the remote control, press the buttons at
intervals of about 1 second to ensure the correct mode
of operation.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot
or humid place.
• Do not spill water or put anything wet on the remote
control.
• Do not open the remote control.
• If the remote control is not going to be used for a long
time, remove the battery to avoid damage caused by
battery leakage corrosion.
Identifi cation of Controls
Connections
Connecting to a TV using an HDMI ® cable
HDMI IN
HDMI Cable
(not included)
HDMI OUT
High
Definition
TV
This connection provides better picture quality and supports up to 1080i/1080p, 1080p/24F resolution.
Connect a HDMI cable from the HDMI output jack on this product to the HDMI input jack on the TV.
Notes:
HDMI connection is required. Cables are not included. Analog connection is not supported. •
Do not tilt the connector when inserting it into the HDMI jack, and make sure the shapes of the jack and the •
connector are matched.
When using a non-HDCP compatible TV, the image will not display properly.
•
An HDMI cable carries both video and audio signals. If you want to use TV speakers, you do not need to make an •
additional audio connection if you are using an HDMI cable.
Point the remote control at the remote sensor
and press the buttons.
POWER
Distance: About 5 m from the front of the remote
sensor.
Angle:
About 30° in each direction of the front of the
remote sensor.