True Manufacturing Company TCGDZ-50 - Manual (Page 17)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
15 15
CLEANING THE CONDENSER COIL
When using electrical appliances, basic safety precautions should be followed, including the following
CONDENSER CLEANING:
TOOLS REQUIRED:
• Phillips screwdriver
• Stiff bristle brush
• Adjustable wrench
• Vacuum
A. Disconnect power to unit.
B. Take off rear lower grill assembly by removing two
(2) bottom screws.
If necessary, loosen screws holding the top pivot
pins. Swing grill up and remove frame hooks from
pivot pins at top of louver.
C. Remove bolts anchoring compressor assembly to
frame rails and carefully slide out (tube connections
are flexible).
D. Clean off accumulated dirt from condensing coil
with a stiff bristle brush.
E. After brushing condenser coil vacuum dirt from
coil and interior floor.
F. Carefully slide compressor assembly back into posi-
tion and replace bolts.
G. Connect unit to power and check to see if con-
denser is running.
H. Reinstall louver assembly onto unit,
tighten all screws.
MAINTENANCE, CARE & CLEANING
STEP D
STEP E