Storage – Tecumseh 850 User Manual

Page 5

Advertising
background image

STORAGE

NEVER STORE ENGINE WITH FUEL IN TANK INDOORS OR

IN ENCLOSED, POORLY VENTILATED AREAS, WHERE

FUEL FUMES MAY REACH AN OPEN FLAME, SPARK OR

PILOT LIGHT AS ON A FURNACE, WATER HEATER,

CLOTHES DRYER OR OTHER GAS APPLIANCE.

IF ENGINE IS TO BE UNUSED FOR 30 DAYS OR MORE, PRE-

PARE AS FOLLOWS:

А

А

DRAIN FUEL SYSTEM:

A. Remove all gasoline from carburetor and fuel tank to

prevent gum deposits from forming on these parts and

causing possible malfunction of engine.
DRAIN FUEL INTO APPROVED CONTAINER OUT-

DOORS, AWAY FROM OPEN FLAME. BE SURE

ENGINE IS COOL. DO NOT SMOKE.

B. Run engine until fuel tank is empty and engine stops due

to lack of fuel.
NOTE: If “Gasohol” has been used, complete above

instructions and then put 1/2 pint of gasoline

properly mixed with oil per FUEL MIX CHART

on Page 2 into fuel tank and repeat above

instructions.

NOTE: Tecumseh "SMART START

TM

" gasoline preser-

vative and stabilizer is an acceptable alternative

in minimizing the formation of fuel gum deposits

during storage. Add stabilizer to gasoline in fuel

tank or storage container. Always follow mix

ratio found on stabilizer container. Run engine

at least 10 minutes after adding stabilizer to

allow it to reach carburetor.

Page 5

STORAGE

(Continued)

Б

Б

DRAIN CARBURETOR

(if so equipped):

Drain carburetor by pressing upward on bowl drain (see

Figure 6), which is located below carburetor (see Figure 1).
DRAIN FUEL INTO APPROVED CONTAINER OUTDOORS,

AWAY FROM OPEN FLAME. BE SURE ENGINE IS COOL.

DO NOT SMOKE.
NOTE:
Do not drain carburetor if using fuel stabilizer.

Figure 6

CARBURETOR

BOWL DRAIN
(optional)

181-807-14

В

В

CYLINDER BORE:

A. Pull starter handle slowly until resistance is felt due to

compression pressure, then stop.

B. Release starter tension slowly to prevent engine from

reversing due to compression pressure. The position will

close both the intake and exhaust ports to prevent

corrosion of the piston and cylinder bore.

Advertising
This manual is related to the following products: