Tandberg Data NAS Hardware Viking FS-1500 - Manual (Page 99)

Tandberg Data Distributed File System
__________________________________________________________________________________________________
7-9 Tandberg Viking Series Storage Server Administration Manual
7.5.2. Add a Namespace Server (Domain)
If you created a domain-based namespace, perform this task to specify an
additional server to host the namespace. Doing so increases the availability
of the namespace and allows you to place namespace servers in the same
sites as users. If you created a stand-alone namespace, you must skip this
task because stand-alone namespaces only support a single namespace
server.
To add a namespace server:
1. In the console tree of the DFS Management snap-in, right-click
\\domain\Public, and then click Add Namespace Server.
2. In Namespace server, type the name of another server to host the
namespace, and then click OK.
After you finish this procedure, click the \\domain\Public namespace in the
console tree and review the contents of the Namespace Servers tab in the
details pane, which should look similar to the following figure. Notice that two
UNC paths are listed. The site of each namespace server is also displayed.
7.5.3. Delegate Management Permissions
You can delegate management permissions so that users who are not
members of the Domain Admins group can create domain-based
namespaces, and you can delegate management permissions so that users
or groups can manage existing namespaces. In this section, you will
delegate permissions to manage the namespace you created in the previous
task.
To delegate permission to manage an existing namespace:
1. In the console tree of the DFS Management snap-in, right-click
\\server_or_domain\Public, and then click Delegate Management
Permissions.
2. Type the name of a user or group that you want to manage the
namespace, and then click OK.
After you finish this procedure, review the contents of the Delegation tab in
the details pane. It should look similar to the following figure.