Solving operational problems – Thermador SMW272 User Manual

Page 60

Advertising
background image

SMW Oven Care and Use Manual

Lower Oven Maintenance

Before calling for service, check the following to avoid unnecessary service charges.

PROBLEM

PROBLEM SOLVING

OVEN

STEPS

All the numbers touched

The numbers were touched too rapidly. Be sure you remove your finger from

do not appear in display

the number pad between digits. Example: 4, 0, 0.

F-1 to F-9, FC, FF, F- or Fr

Touch OFF or turn power off at the circuit breaker, wait 3 minutes and turn

flash in the display

it back on. If condition persists, note the code number and call an authorized
servicer.

F-7

This is caused by close contact to the control panel for more that 32 seconds,
such as someone leaning against the controls or objects hanging in front of
controls. Follow previous solution.

Clock and timer

Make sure there is proper electrical power to the oven.

do not work

See the CLOCK and TIMER sections on Pages 30 & 31.

Cooling fan continues to

The fan turns off automatically when the electronic components have cooled

run after oven is turned off.

sufficiently.

Oven will not work

Make sure there is proper electrical power to the oven.
Check the circuit breaker or fuse box to your house.

Oven light does

Replace or reinsert the light bulb if loose or defective (See Page 54).

not work

Touching the bulb with your fingers may cause the bulb to burn out quickly.
Oven light does not work if CLEAN mode is set.

Oven temperature is

The oven thermostat needs adjustment. See the OVEN TEMPERATURE

too hot or too cold

CALIBRATION in Do-It-Yourself Maintenance, Page 56.

Oven will not self-clean

The oven temperature is too high to set the self-clean operation.
Allow the oven to cool to room temperature and reset the controls.
Be sure you have touched CLEAN.

The oven door will not

Allow the oven to cool below the locking temperature.

unlock

Oven is not clean

Heavily soiled ovens may need to self-clean again or for a longer

after the clean cycle

period of time. Heavy spillovers with soft or liquid centers should be wiped up
before starting the clean cycle. See Self-Cleaning the Oven, Pages 50 and 51.

Solving Operational Problems

For authorized service or parts information, call 800/ 735-4328.

We want you to remain a satisfied customer. If a problem does come up that cannot be resolved to
your satisfaction write to Thermador Customer Support Call Center, 5551 McFadden Avenue,
Huntington Beach, CA 92649 or phone: 800/ 735-4328.

Please include the Model Number, Serial Number and Date of Original Purchase/Installation.

HOW TO OBTAIN SERVICE

Page 58

Advertising