T+A Elektroakustik CD Player K1 AV - Manual (Page 37)

Amplifier Setup Menu point Volume setting, separate
Explanation:
Normally the volume for the loudspeaker outputs  A and  B is controlled in parallel.
However, if you connect the E2000 external remote control receiver, and if a pair of
loudspeakers is connected to loudspeaker terminals  B (preferably in an adjacent room),
this menu point can be used to set up separate volume control for the loudspeaker pairs
 A and  B.
If the multi-room option is selected, only the speakers in the operator’s room will be activated
when you switch on the K1 AV; the other pair of speakers remains muted.
The volume for  A can only be adjusted using the  buttons on the machine, or via
the integral remote control receiver.
The volume for  B can only be adjusted using the external remote control receiver (see
also the chapter 'Multi-room mode').
Operation:
The screen shows the current status of the system:
'VOL A/B' separate volume control for multi-room use.
or
'VOL A+B' parallel volume control for single-room use.
Select your preferred option using the buttons  or . The menu closes when you
press the  button.
If the menu control buttons (, , , ,  or ) are not operated for a
period of about ten seconds, the amplifier interrupts the menu (Timeout) and reverts to the
normal screen display.
37
vol a/b