TMC ET4000 - Manual (Page 55)

Memory Dialing
Using Memory Dial
To store a memory dial num-
ber:
1 Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under MEM.
- The display will read “Select
Location”
3 Press the Memory button where you
wish to store the number, or press
LOWER followed by the desired
memory button if you wish to store
the number in a lower memory loca-
tion.
- The display will show the currently
stored number, or indicate “Empty
Location.”
4 Press the soft key under CHANGE if
you wish to store a new number.
5 Dial desired telephone number, up
to 32 digits.
6 Press the soft key under SAVE.
You may store up to 28 telephone numbers at
your telephone which you can dial automatically
with the press of a memory button.
Note that you can enter hyphens in your num-
bers for easy reading, as well as flashes and
pauses (see page 48).
To dial a memory dial number:
1 Press the memory button where the desired
telephone number is stored.
OR
Press LOWER followed by the desired
memory button if you wish to dial a number
stored in a lower memory location.
When you press a memory button, the speaker-
phone turns on automatically, and the number is
dialed out. You may lift the handset or press
HEADSET to switch to a handset or headset call
at any time.
Press Memory
button to dial
numbers in white
spaces
Press LOWER,
then Memory button
to dial numbers in
gray spaces
45
Note: If you ever wish to erase the
memory dial numbers stored in your
phone, please follow the instructions
found on page 49.
ET4000 UG for PDF v8 062502.qxd 6/25/02 12:52 PM Page 55