Toshiba TDP-P9 - Manual (Page 28)

28
Operations Turning the power on and off
„ Connecting the power cord
Insert the power cord connector into the AC IN
socket of the projector.
Insert the power cord plug into a wall or other
power outlet.
The TEMP, ON/STANDBY and LAMP indicator will flash,
and then ON/STANBY will only remain flashing, indicating
standby mode.
„
Removing the lens cover
Be sure to remove the lens cover when the power is turned on.
If it is left on, it could become deformed due to heat.
„ Turning the power on
Press the ON/STANDBY button.
The power turns on and the ON/STANDBY
indicator lights. After a moment, the start-up
screen appears.
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may
cause damage to your eyesight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal
overheating.
• Do not place your hands, face, or other objects near the air exhaust, the lamp
cover or the bottom of the unit. Doing so could cause burns, deform/break the
object.
Control panel
Remote
Control Start-up screen