Tripp Lite B020-016-17 - Manual (Page 15)

15
6. Hotkeys
(Continued)
The Beeper can be turned On/Off via Hotkey or the OSD (see pages 16-21 for OSD details).
To toggle the Beeper, key in the following Hotkey combination:
Invoke Hotkey Mode with the 1) [Num Lock] + [-] combination
Key in 2) [B]
After you press [B], the Beeper toggles On or Off. The Command Line displays Beeper On or
Beeper Off
for one second; then the message disappears and you automatically exit Hotkey Mode.
6.11 Hotkey Beeper Control
Hotkey Sequence – Starting with [Num Lock] + [-] or [Num Lock] + [*] then …
[Port ID] [enter] Switches access to the computer connected to that Port ID.
[T] [n] [enter] Sets the Auto Scan interval to n seconds - where n is a number from 1 - 255.
[A] Invokes Auto Scan Mode.
[] Invokes Skip Mode and skips from the current port to the first accessible port
previous to it.†
[] Invokes Skip Mode and skips from the current port to the next accessible port. †
[] Invokes Skip Mode and skips from the current port to the last accessible port of
the previous Station.†
[] Invokes Skip Mode and skips from the current port to the first accessible port of
the next Station.†
[B] Toggles the Beeper On or Off.
† Once Skip Mode has been invoked and until you exit, you can keep on skipping simply by pressing an Arrow key. You don’t have to use
the [Num Lock] + [-] combination again.
6.12 Hotkey Summary Table