Format introduction – Transcend Information TS128M~8GJF2A User Manual
Page 10

Format Introduction
JetFlash Product Number,
Drive Letter and Capacity
Information of Partitioned Disk 1
Disk-Volume bar. Use it to make
two partitions and adjust the
capacity sizes. The minimum
size is 2MB.
Information of Partitioned Disk 2
Progress bar
Type of Format
Quick: Erase and check blocks at the same time. If there are any bad blocks, mark
them as Bad and perform a DOS format.
Full:
Do a Surface Scan for a Read/Write Check. A Read/Write Check can find if
there is any bad block which will be marked as Bad and perform a DOS format.
Configure device only:
Partition JetFlash, and set up password protection and
boot-up information.
Configure device only cannot be setup under password protection.
WARNING: All data on JetFlash will be lost during execution of this procedure!
8