Tiger Mowers SIDE FLAIL ASEMBLIES JD 5085M-105M - Manual (Page 41)

ASSEMBLY
Assembly Section 2-15
FILLING HYDRAULIC RESERVOIR
Refer to the maintenance section for filling specifications and hydraulic oil requirements.
NOTE: Starting or running your T iger mower before filling reservoir will cause
serious damage to hydraulic pump.
(ASM-C-0004hydro resrv)
WHEEL SPACER WITH WHEEL WELL TANK
When the left wheel is off, a spacer kit is needed with the wheel well tank (part# 06200637.)
Attach the spacer to the left wheel portion of the axle with the hardware provided. When you are
ready to re-attach the left wheel, the wheel goes on first then the reinforcement ring and finally
the hardware provided.
(ASM-JD-0070)
INSTALLING O-RING FITTINGS
Installing straight, 45º and 90º O-rings requires that the O-ring and washer be up against the
swivel body. Insert the swivel and turn in until the swivel is pointed in the desired direction and O-
ring contact is made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
(ASM-C-0056)
INSTALLING NATIONAL PIPE FITTINGS
Whenever installing a pipe fitting, wrap the threads clockwise (looking at the end) with teflon
tape. In this way, the tape will be tightened when installed. NOTE: It is not necessary to tape O-
ring fittings, or those installed in swivels.
(ASM-C-0088)
GENERAL HOSE INSTALLATION
Refer to the parts section for detailed information about hoses and fittings for this application.
(ASM-C-0011)
HOSE COVERING
Secure hoses together with zip ties wherever loose. Wrap the hoses between the swivel and
main boom with the hose cover provided. Wrap the hoses between the main boom and
secondary boom with the hose cover provided. Where hoses may contact the frame or other
edges, wrap with split hose and secure with hose clamps or zip ties.
On non cab units, the pressure and return hoses from the control valve will also need to be
routed inside the protective clear hose wrap. Cover the valve, valve fittings with the yellow hose
cover and secure with black string provided.
(ASM-C-0058)
SOLENOID BRAKE VALVE
Install a solenoid valve on the mounting bracket with the supplied hardware as shown in the
Parts Section in this manual. While installing the fittings to the brake valve, the electical coil on
the spool may have to be removed to make room. When reinstalling the coil, it is important to
use no more than 5 ft. lbs. (or 60in. lbs.) torque. WARNING: OVER TORQUE TO THE COIL
WILL RESULT IN HYDRAULIC FAILURE OF SPOOL.
(ASM-C-0025)