Triax DVB 75SI - Manual (Page 7)

TRIAX DVB 75 SI
7
7KHIURQWRIWKHVDWHOOLWHUHFHLYHU
1)
Standby (on/off) button
2) Step-by-step change of
programme/channel.
3) Embedded Viaccess smart card
reader.
4) Common Interface slot
(For PCMCIA CA modules. For
decoding via different Common Access
standards)
7KHUHDURIWKHVDWHOOLWHUHFHLYHU
5)
LNB INPUT: For connection of the
aerial cable from the LNB unit.
6) AERIAL IN: For connection of the
cable from a VHF/UHF antenna or a
cable system.
7) TV OUT: For connection to a television
set via an RF aerial cable.
8) TV: SCART connector for connecting
the satellite receiver to a television set.
Cable included.
9) VCR: SCART connector for connecting
the satellite receiver to a VCR.
10) L/R AUDIO: Phono connector with
stereo audio signal for connecting the
satellite receiver to a HI-FI stereo set.
11) Digital audio: Phono connector with a
digital audio signal.
12) Phone: Telephone connector for
connection to an analog telephone
connection
13) Mains connection: The satellite
receiver is ready for operation when
connected to the mains (230V, 50Hz)
14) RS232: For connection of a PC.
7KHUHPRWHFRQWURO
15) Standby (On/Off). Sets the receiver in
standby mode. It will start from the
favourite list and the channel last used.
16) Muting: Temporary sound switch-off.
17) A/B: Activates the audio menu on the
screen in case of channels with several
audio tracks.
18) TV/SAT: Switches between TV, VCR
and SAT signals to the television set.
19) TV/R: Switches between digital
television and radio reception.
20) 0-9: Numeric buttons from 0 to 9 for
direct entry of programme place num-
bers and other numeric entries. When
using interactive services, the buttons
are taken over by the application.
21) P+ and P-: Step-by-step change of
programme.
22) Info: Activates information banner
23) exit: Exits running application or menu.
24) back: Goes back to the previous level
of the interactive application or the
main menu.
25) menu: Activates and displays the
receiver main menu for system
settings.
26) guide: On Viasat channels the Viasat
OpenTV portal application is activated,
and on other channels the Triax EPG
is activated.
27) V+ and V-: Step-by-step volume ctrl.
28) OK: Opens and displays the current
programme list and confirms entries.
29) Cursor buttons: Active during
interactive applications and in the main
menu for change of function and line
on the screen.
Outside applications: Up/Down
functions as channel switch and
left/right as volume control.
30) Red, Green, Blue, Yellow: Function
buttons the function of which depends
on the interactive application active at
any time.
Function at normal television reception:
yellow = Triax EPG
blue = Subtitle language on pay-TV
channels
green = Channel/signal information
When in standby mode the receiver
may also be started by means of these
buttons and thus your respective
favourite programme lists will be
activated:
red = Danish programme list
yellow = Swedish programme list
blue = Norwegian programme list
green = Viasat/General programme list