TRENDnet TW100 BRF114 - Manual (Page 9)

Introduction
5
Rear Panel
Figure 3: Rear Panel
Reset Button This button has two (2) functions:
• Reboot. When pressed and released, the TW100-BRF114 will
reboot (restart).
• Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button down for five (5) seconds, until
the Red Status LED has flashed TWICE.
4. Release the Reset Button. The TW100-BRF114 is now using the
factory default values.
WAN port
(10/100BaseT) Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
10/100BaseT
LAN connections Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
Note:
Any LAN port on the TW100-BRF114 will automatically function as
an "Uplink" port when required. Just connect any port to a normal
port on the other hub, using a standard LAN cable.
Power port Connect the supplied power adapter here.