Philips FC7070 - Manual (Page 25)

25
Problem Possible cause Solution
The inside of the mop-
ping nozzle is too dirty.
Clean the mopping nozzle (see chapter ‘Cleaning and
maintenance’, section ‘Cleaning the mopping nozzle’).
The mopping brushes are
not present.
Place the mopping brushes in the mopping nozzle
(see chapter ‘Cleaning and maintenance’, section
‘Reassembling the mopping nozzle’).
The mopping brushes are
worn.
Replace the mopping brushes (see chapter ‘Replacing
the mopping brushes’).
The sound of
the appliance
changed while
cleaning.
The active protection
system may have been
activated for three
reasons: (1) the appli-
ance picked up a foreign
object, (2) the mopping
brushes are too wet or
(3) you have moved the
appliance over a carpet.
The mopping brushes
automatically stopped
rotating because they
encountered too heavy
resistance. The appli-
ance continues to make
a sound, but it does not
work properly.
Release the power-on button to switch off the ap-
pliance. Put the appliance upright in parking position
(‘click’) and pull the plug out of the wall socket. Open
the mopping nozzle lid, remove the mopping brush
cover and remove the object. Reinsert the mopping
brush cover, close the mopping nozzle lid, put the
plug in the wall socket and switch on the appliance
again (see chapter ‘Using your AquaTrio’, section
‘Active protection system is activated’). If you find no
object, the active protection system may have been
activated because the mopping brushes are too wet
(see next cause and solution) or because you moved
the appliance over a carpet. Pull the plug out of the
wall socket, open and close the mopping nozzle lid,
put the plug in the wall socket again, switch on the
appliance and start cleaning again.
If the above solutions did not help and the appliance
still does not work, switch on the appliance for at
least 10 seconds. Then open and close the mopping
nozzle lid, switch on the appliance and start cleaning
again.
The active protection sys-
tem has been activated
because the brushes are
too wet. The mopping
brushes automatically
stopped rotating because
they encountered a too
heavy resistance.
Release the power-on button to switch off the ap-
pliance. Put the appliance upright in parking position
(‘click’) and pull the plug out of the wall socket.
Remove the mopping brushes from the mopping
nozzle and remove excess water from the mopping
brushes by squeezing them over a sink (see chapter
‘Cleaning and maintenance’, section ‘Cleaning the
mopping nozzle’). Then you can reinsert the mopping
brushes, reinsert the mopping brush cover, close the
mopping nozzle lid, put the plug in the wall socket
and switch on the appliance again (see chapter
‘Cleaning and maintenance’, section ‘Reassembling
the mopping nozzle’). If this does not work, let the
mopping brushes dry (see chapter ‘Cleaning and
maintenance’, section ‘Cleaning the mopping nozzle’).
EN
g
LISH