Tascam GigaStudio User Manual
Page 159
TASCAM GigaEditor 4 Manual
159
Th e range is 0-127, with a default value of 60 (middle C).
Velocity scale
This value is used to scale the currently selected velocity curve in order to specify a much larger number of
filter velocity responses. For example, if you want the filter to scale from a low cutoff to fully open within
the lowest velocity range, the filter response can be scaled to open more quickly by entering values above 20
(up to 127). Values below 20 will cause the filter to open more slowly over velocity yielding a darker
response. Th e range is 0-127 with a default value of 20. Th is parameter is only available when the Cutoff
Controller is set to “None”.
Filter velocity response curve
Defines how the filter responds to note-on velocity.
•
0 - Non linear
•
1 - Linear
•
2 - Special
Th ese settings work in conjunction with the Velocity dynamic range parameter (see the next item).
Filter velocity response dynamic range
With this setting, you can lower or raise the dynamic range of the velocity response of
the filter. Th ere are five response positions:
•
1 - High
•
2 - Medium high
•
3 - Medium
•
4 - Medium low
•
5 - Low
This setting works in conjunction with the Velocity curve parameter (above) as shown in the following
diagrams: